"power+supply"

This six-outlet power strip extends the functionality of electrical outlets, and gives extra reach to electrical cords.

Ideal choice for protein or nucleic acid separations.

A staple for any lab or classroom. USB charger for up to 5 devices with a 5 foot power cord.

This battery eliminator features overload protection.

This charger works with all Boreal, National and Motic Swiftline cordless LED microscopes.

Explore solar energy with this innovative science kit designed to help students investigate energy transformations. A hinged box helps students discover how the angle of photovoltaic panels relative to the sun affects power output. Compare your experimental findings to online sun-angle calculators.

Celestron’s AC Adapter, made exclusively for the CGEM and CGE Pro mounts.

The Vernier Resistor Board has seven 1 W 5% resistors mounted on a circuit board.

The instrumentation amplifier can be used to connect a wide variety of measurement equipment to a Vernier interface and electronically collect, store, and analyze the data.

This is the primary generator for wind turbine experiments because it runs smoothly and provides high power output at a relatively low RPM. This is the competition generator used in KidWind Challenge events. This generator has 4-foot leads which are attached with shrink-wrapped, reinforced soldering. Typical output in non-geared wind devices is 0.5–2.5 V at 0.1–0.3 A.

Type 3 Voltage Converters are thoroughly tested to the highest workmanship and material standards and hand soldering insures to meet U.S Military specifications.

The Go Direct® charge station is the perfect solution for charging Go Direct sensors.

The High Torque Generator is another option for your wind turbine generator. When compared to the standard Wind Turbine Generator, this High Torque Generator will produce lower voltage but higher current for a given rotor RPM. The High Torque Generator is great for load devices with higher current draw, such as the water pump. This generator has the same 2 mm driveshaft as the standard Wind Turbine Generator, so the Wind Turbine Hub is interchangeable with either motor. The generator also has 4-foot leads with shrink-wrap reinforced soldering.

This kit is a learn-by-building introduction to a motor’s basic components.

Recharge TI-Nspire CX calculators with ease.

Set of two copper leads with highly flexible PVC insulation, 75 cm long, black, with stackable 4 mm safety laminated plugs at both ends.