Filters
Search Within
Power Supplies
Power supplies convert one form of energy to another that is required for proper equipment operation. Protecting against short circuit and excessive voltage incidents, the working longevity of expensive machines will not be compromised. In case of power failure, the electronic devices automatically recover functions to guard sensitive materials. Regulated, unregulated, or adjustable power supplies are categorized based on the general performance producing steady currents or voltages at precise levels.
Filters
Search Within
Multi-Range DC Power Supply
This unit can replace multiple supplies on your lab bench.
Expand 1 item
Programmable DC Power Supply
A must for the lab that needs precise voltage or current.
Expand 2 item
Vernier® Resistor Board
The Vernier Resistor Board has seven 1 W 5% resistors mounted on a circuit board.
Expand 1 item
DC Power Supply 0 to 500 V
Low voltage power supply with four outputs primarily intended to simultaneously supply power for the Teltron line of electron tubes and Helmholtz Coils, with four independent, adjustable DC voltages. The DC voltages are stabilized, regulated, floating, and galvanically isolated from one another, in addition to being short circuit proof and secure from external voltages.
Expand 1 item
Vernier® AC Adapter
This is a 6 volt, DC, tip-negative power supply for use with Vernier LabPro, CBL 2, Digital Control Unit, and Wireless Dynamics Sensor System.
Expand 1 item
KidWind® Wind Turbine Generators
This is the primary generator for wind turbine experiments because it runs smoothly and provides high power output at a relatively low RPM. This is the competition generator used in KidWind Challenge events. This generator has 4-foot leads which are attached with shrink-wrapped, reinforced soldering. Typical output in non-geared wind devices is 0.5–2.5 V at 0.1–0.3 A.
Expand 1 item
KidWind® High Torque Generator
The High Torque Generator is another option for your wind turbine generator. When compared to the standard Wind Turbine Generator, this High Torque Generator will produce lower voltage but higher current for a given rotor RPM. The High Torque Generator is great for load devices with higher current draw, such as the water pump. This generator has the same 2 mm driveshaft as the standard Wind Turbine Generator, so the Wind Turbine Hub is interchangeable with either motor. The generator also has 4-foot leads with shrink-wrap reinforced soldering.
Expand 1 item
KidWind® Solar Energy Exploration Kit
Explore solar energy with this innovative science kit designed to help students investigate energy transformations. A hinged box helps students discover how the angle of photovoltaic panels relative to the sun affects power output. Compare your experimental findings to online sun-angle calculators.
Expand 1 item
USB Charger for 5 Devices
A staple for any lab or classroom. USB charger for up to 5 devices with a 5 foot power cord.
Expand 1 item
TI-84 Plus CE Charging Station
Recharge the TI-84 Plus CE with ease.
Expand 1 item
Approved Power Supplies, 0 to 30 VDC
A high-quality, regulated power supply for the laboratory.
Expand 1 item
Vernier® Go Direct™ Charge Station
The Go Direct® charge station is the perfect solution for charging Go Direct sensors.
Expand 1 item
DC Power Supply
High-quality switched-mode power supply in space-saving housing with intelligent control of fan speed to ensure safe and quiet operation.
Expand 1 item
Experimental Safety Leads Set
For electrical circuits with low voltages and high currents; copper wire encased in highly flexible PVC; equipped at either end with a laminated plug and a fully-insulated axial jack for connecting additional patch cords.
Expand 1 item
Extra Low Voltage Safety Leads
Set of two copper leads with highly flexible PVC insulation, 75 cm long, black, with stackable 4 mm safety laminated plugs at both ends.