Power Supplies
Power supplies convert one form of energy to another that is required for proper equipment operation. Protecting against short circuit and excessive voltage incidents, the working longevity of expensive machines will not be compromised. In case of power failure, the electronic devices automatically recover functions to guard sensitive materials. Regulated, unregulated, or adjustable power supplies are categorized based on the general performance producing steady currents or voltages at precise levels.
Applied Filters
Vernier® Power Amplifier Accessory Speaker
Power supply, Vernier®, Vernier power amplifier accessory speaker
Expand 1 item
Vernier® Go Direct™ Charge Station
The Go Direct® charge station is the perfect solution for charging Go Direct sensors.
Expand 1 item
DC Battery Eliminator, 1 Amp
This battery eliminator features overload protection.
Expand 1 item
Charger for Select Cordless LED Microscopes
This charger works with all Boreal, National and Motic Swiftline cordless LED microscopes.
Expand 1 item
KidWind® High Torque Generator
The High Torque Generator is another option for your wind turbine generator. When compared to the standard Wind Turbine Generator, this High Torque Generator will produce lower voltage but higher current for a given rotor RPM. The High Torque Generator is great for load devices with higher current draw, such as the water pump. This generator has the same 2 mm driveshaft as the standard Wind Turbine Generator, so the Wind Turbine Hub is interchangeable with either motor. The generator also has 4-foot leads with shrink-wrap reinforced soldering.
Expand 1 item
DC Motor Kit, Single Kit
This kit is a learn-by-building introduction to a motor’s basic components.
Expand 2 item
USB Charger for 5 Devices
A staple for any lab or classroom. USB charger for up to 5 devices with a 5 foot power cord.
Expand 1 item
Vernier® Resistor Board
The Vernier Resistor Board has seven 1 W 5% resistors mounted on a circuit board.
Expand 1 item
Celestron AC Adapter, 5 A
Celestron’s AC Adapter, made exclusively for the CGEM and CGE Pro mounts.
Expand 1 item
KidWind® Wind Turbine Generators
This is the primary generator for wind turbine experiments because it runs smoothly and provides high power output at a relatively low RPM. This is the competition generator used in KidWind Challenge events. This generator has 4-foot leads which are attached with shrink-wrapped, reinforced soldering. Typical output in non-geared wind devices is 0.5–2.5 V at 0.1–0.3 A.
Expand 1 item
TI-84 Plus CE Charging Station
Recharge the TI-84 Plus CE with ease.
Expand 1 item
Experimental Safety Leads Set
For electrical circuits with low voltages and high currents; copper wire encased in highly flexible PVC; equipped at either end with a laminated plug and a fully-insulated axial jack for connecting additional patch cords.
Expand 1 item
Low Voltage Safety Leads
Set of 2 copper leads in highly flexible PVC coating, 75 cm long, with 4 mm laminated safety plugs at both ends.
Expand 1 item
Type 3 Voltage Converters, Step Up and Step Down Voltage Transformer
Type 3 Voltage Converters are thoroughly tested to the highest workmanship and material standards and hand soldering insures to meet U.S Military specifications.
Expand 3 item
USB-C Charging Station, 12-Port
Simplify device charging in classrooms and shared spaces with Luxor's 12-port USB-C charging station.