Power Supplies
Power supplies convert one form of energy to another that is required for proper equipment operation. Protecting against short circuit and excessive voltage incidents, the working longevity of expensive machines will not be compromised. In case of power failure, the electronic devices automatically recover functions to guard sensitive materials. Regulated, unregulated, or adjustable power supplies are categorized based on the general performance producing steady currents or voltages at precise levels.
Multi-Range DC Power Supply
This unit can replace multiple supplies on your lab bench.
Expand 1 Items
Programmable DC Power Supply
A must for the lab that needs precise voltage or current.
Expand 2 Items
Vernier® Resistor Board
The Vernier Resistor Board has seven 1 W 5% resistors mounted on a circuit board.
Expand 1 Items
DC Power Supply 0 to 500 V
Low voltage power supply with four outputs primarily intended to simultaneously supply power for the Teltron line of electron tubes and Helmholtz Coils, with four independent, adjustable DC voltages. The DC voltages are stabilized, regulated, floating, and galvanically isolated from one another, in addition to being short circuit proof and secure from external voltages.
Expand 1 Items
Vernier® AC Adapter
This is a 6 volt, DC, tip-negative power supply for use with Vernier LabPro, CBL 2, Digital Control Unit, and Wireless Dynamics Sensor System.
Expand 1 Items
KidWind® Wind Turbine Generators
This is the primary generator for wind turbine experiments because it runs smoothly and provides high power output at a relatively low RPM. This is the competition generator used in KidWind Challenge events. This generator has 4-foot leads which are attached with shrink-wrapped, reinforced soldering. Typical output in non-geared wind devices is 0.5–2.5 V at 0.1–0.3 A.
Expand 1 Items
KidWind® High Torque Generator
The High Torque Generator is another option for your wind turbine generator. When compared to the standard Wind Turbine Generator, this High Torque Generator will produce lower voltage but higher current for a given rotor RPM. The High Torque Generator is great for load devices with higher current draw, such as the water pump. This generator has the same 2 mm driveshaft as the standard Wind Turbine Generator, so the Wind Turbine Hub is interchangeable with either motor. The generator also has 4-foot leads with shrink-wrap reinforced soldering.
Expand 1 Items
KidWind® Solar Energy Exploration Kit
Explore solar energy with this innovative science kit designed to help students investigate energy transformations. A hinged box helps students discover how the angle of photovoltaic panels relative to the sun affects power output. Compare your experimental findings to online sun-angle calculators.
Expand 1 Items
USB Charger for 5 Devices
A staple for any lab or classroom. USB charger for up to 5 devices with a 5 foot power cord.
Expand 1 Items
TI-84 Plus CE Charging Station
Recharge the TI-84 Plus CE with ease.
Expand 1 Items
Approved Power Supplies, 0 to 30 VDC
A high-quality, regulated power supply for the laboratory.
Expand 1 Items
Vernier® Go Direct™ Charge Station
The Go Direct® charge station is the perfect solution for charging Go Direct sensors.
Expand 1 Items
DC Power Supply
High-quality switched-mode power supply in space-saving housing with intelligent control of fan speed to ensure safe and quiet operation.
Expand 1 Items
Experimental Safety Leads Set
For electrical circuits with low voltages and high currents; copper wire encased in highly flexible PVC; equipped at either end with a laminated plug and a fully-insulated axial jack for connecting additional patch cords.
Expand 1 Items
Extra Low Voltage Safety Leads
Set of two copper leads with highly flexible PVC insulation, 75 cm long, black, with stackable 4 mm safety laminated plugs at both ends.